News

Location: Home > News > Industry News... > Die-casting dies man...

Industry News

Die-casting dies management 7

  Time : 05.06.2019   Source :     Click :

Die-casting dies management 7

P2 is an engine case on the right motorbike.Original ingate was designed to an horizontal construction,the  yellow part was original flow gate, parting line go through the B part. Workers must remove the burr and keep the surface smooth, because later this part will be machined a oil hole, in the process, the drill may damaged easily because B part’s burr and unfairness.Early nearly have no communication with factory ,so always the factory usually make moulds by old technology, increase workload. Then talk with mould factory , improve the ingate’s design. Improve the B part into a facet, it’s helpful for locate the drill, and remove burr no longer.At the same time, we can ensure  the die casts’ quality and the machining process will go on normally.


Prev:Die-casting dies management 8

Next: Die-casting dies management 6

About Us|Contacts|Disclaimer|sitemap

Copyright©Ningbo Angus Die casting Technology Co., Ltd.