Time : 06.04.2015 Source : Click :
before optimize |
after optimize |
![]() |
![]() |
Each project starts with a deep understanding of customer needs. Our engineers can understand the product use and performance requirements after communication with customer.With years of experience and practical knowledge, engineers will put forward some suggests the following aspects after comparison of structure design and multiple mode flow analysis.
1)Product structure optimization;
2)Product lightweight;
3)Product intergration.
By product structure optimization and light weight, the cost will be reduced, it's more important to reduce the defects in the product structure to improve the performance of the products and reduce the defects in the die structure so that the service life of the die and stability of mold are increased.
Before die design, our engineering team will review customer's product design and issue feasibility report, offering proposals, improving of manufacturability, shorten cycle time, reduce cost and enhance quality.
Our engineer team will offer all assistance and necessary information required to create your product. which throughout the entire production process.
Optimize the parts is the key point for every project, and our target is try our best to meet customer's conceive.
Prev:No prev
About Us|Contacts|Disclaimer|sitemap
Copyright©Ningbo Angus Die casting Technology Co., Ltd.